Use an easy to handle air hammer to help install filter cloths on your filter plates.
The Air Hammer will operate from 60 PSI to 125 PSI and should be regulated to what is best for your particular application. Operation above 125 PSI may cause internal damage
To insure maximum air flow proper operation we recommend 3/8″ hose and fitting. Although the tool uses only 2 to 4 C.F.M. at maximum operating speed, you should insure maximum air flow for proper operation. If air flow is restricted it is recommended that you install a 3 to 5 gallon surge tank within 15 of the work area.
Since the Air Hammer is a high speed pneumatic tool, trouble free use is best obtained by using a 3/8″ or larger air filter and lubricator. However, the Air Hammer may be used (but not recommended) without an air filter or lubricator by following these important instructions:
Single Hammer Blow: A light tap of the hammer tip against the workpeice and instant withdrawal away from the workpiece will permit a single hammer blow.
Mulitple Hammer Blows: A light tap of the hammer tip against the workpeice and continued light pressure against the workpiece will permit continuous hammering.
Alawys use a non-detergent oil, 6 to 10 weight, for lubrication.
Need help installing filter cloths and gaskets, please watch our videos or contact us.
| Condition |
|---|
Met-Chem, Inc.
837 East 79th St.
Cleveland, OH 44103
Phone: (216) 881-7900
Email: info@metchem.com
A Senney Enterprise Company
Copyright © Met-Chem, Inc
